UPS UPS can be used with ACTAtek in order to have continuous DC 12V power supplied. Sites that often have power supply failure may consider to install a UPS as backup power supply.
Features - Exquisite design
- Easy installation for every user
- Low battery alarm
- Automatic shutdown
- User friendly design of swapping battery
- Cold start (DC power on)
- Short circuit and overload protection
- Horizontal positioning or wall mount positioning capability allows you to place anywhere you like where power source is needed
- Full time detection utility power status
- No transfer time
- Wide AC input voltage windows ( +/-25%)
- Line ok, back-up LED display
- Output DC 12V
Specifications| MODEL | | DC 9V UPS | DC 12V UPS | DC 18V UPS | DC 24V UPS | | OUTPUT | Capacity (W) | 30 W | 30 W | 30 W | 30 W | | No. of sockets | Two DC UPS Sockets | | Voltage (on battery) | DC 12V +/-15% DC 9V/18V/24V +/-10% | | Transfer Time | <5 millisecond | | LED (on battery) | Green LED flash every 3 seconds | | INPUT | Voltage (single phase) | AC 110V/220V +/-25% at line input (optional : 86V ~ 276V at line input) | | Frequency | 50 or 60 Hz | | LED (on AC mode) | Green LED always light | | PROTECTION | Unit Input | Fuse for overload & short circuit protection | | Overload Protection | UPS automatic shutdown if overload | | Short Circuit | UPS output cut off immediately | | BATTERY | Type | Sealed, maintenance-free lead acid batteries, with 3-6 years typical lifetime | Typical Recharge Time (to 90% of full capacity) | 4 hours | Back-up Time (depend on load) | 90 - 120 minutes | | Protection | Shutdown when battery voltage drops below 10V, Over discharge protection, short circuit protection by fuse. | | PHYSICAL | Net Weight kg (lbs) | 3.0 (6.6) | Dimension W x D x H (mm) | 267 x 155 x 64 (10.5" x 6.1" x 2.5") | | ALARM | Battery Low | Rapid beeping sound every 3 seconds | | ENVIRONMENT | Ambient Operation | 3,500 meters max. elevation, 0-95% humidity (No-condensing water), 0-40 deg | | Audible noise | < 40dBA (1 meter from surface) |
|